1/2" Light Grey T-Molding

1/2" Light Grey T-Molding
Average rating:
| Read all reviews

SKU T-LGRY-50
Slot Width 1/16"
PMS Color 430
Starting Price $0.50 per foot
Quantity   20 - 249     250 - 999     1000+  
Price $0.50 $0.37 $0.32
Qty:    
  • More Details
  • Reviews
  • Related Items:

1/2" Light Grey T-Molding

This 1/2" Light Grey T-Molding is priced per foot, and will ship as one continuous piece of molding up to 250ft long.

1/2" Light Grey T-Molding Reviews

Read all reviews

Featured positive reviews:

1/2" Light Grey T-Molding
Great Company to Deal With!
By 
Great site, very fast shipping even to CA, and very reasonable price, great company to deal with!

I used the T-Molding to replace some old (1997) trim on a table top in a boat. In some places, the routed out groove on the table was worn, so the T-Molding fit was loose in places, generally around a corner/curve. This was resolved by adding a layer or two, of masking tape over the center T-Molding rib to tighten the fit in the routed out table groove.

The job ended up looking nice, but there was a small hairline gap because the overall thickness was just slightly thicker than 1/2" (my fault measuring). I ordered the next size up (5/8"), installed and trimmed to fit, perfect!
1/2" Light Grey T-Molding
Great purchase
By 
The T-molding was well packaged, promptly shipped and arrived in perfect condition. The dimensions were just as described, and the molding was easy to apply. On a scrap piece applied to a scrap board for practice, I pulled the T-molding back off, just to test the “staying power”. I have good confidence that this stuff will not come out, accept when deliberate effort is made to remove it.
Customer service was great! They answered my few technical questions before I purchased promptly, courteously and thoroughly, with further suggestions for installation. Great company.
 

1/2" Light Grey T-Molding Related Items:

whiteside-6700a-cutter
Whiteside Slotting Cutter 1/16" 3-WingWhiteside Slotting Cutter 1/16" 3-Wing
Average rating:
Use with T-Molding that has a 3/32" wide spine (including the barbs).

Requires a slot cutting arbor, such as the A200B or equivalent.
Price $17.95
whiteside-a200b-arbor
Whiteside Slotting Cutter Arbor 1/4" ShankWhiteside Slotting Cutter Arbor 1/4" Shank
Average rating:
For use with all of our slot cutter router bits, for routers that use 1/4" shanks.
Price $9.95
Share on Facebook Pin It
Bookmark and Share